Had a couple of things to do before the weekend. Balance the carbs on the 500, and swap the shock bolt aruond on the FZR. I couldn't work out how to take the weight off the FZR rear end, without another set of hands, so instead I made it fit the side it was by grinding the washer so that it would fit, it does mean that you have to hold the bolt on the other side but it will do for this weekend.
Had to move all the bikes out of the garage to run the RG to balance the carbs. I use an air flow meter to measure the "suck" of each carb at a fixed carb setting. All done, except I need to fit the fairings and then we ready to load the van.
Yup need to change the angle of the belly pan on the FZR.
Had to move all the bikes out of the garage to run the RG to balance the carbs. I use an air flow meter to measure the "suck" of each carb at a fixed carb setting. All done, except I need to fit the fairings and then we ready to load the van.
Yup need to change the angle of the belly pan on the FZR.
No comments:
Post a Comment